TM
9-2350-222-20-2-3-2
30-12. MOUNT, SEAL, AND BEARING REMOVAL PROCEDURE
TOOLS: Cross tip screwdriver (Phillips )
PERSONNEL: One
EQUIPMENT LOCATION INFORMATION:
FOLDOUT
CALLOUT
EQUIPMENT
11
Driver's Master Control Panel
5
Loader's Escape Hatch
EQUIPMENT CONDITION: Driver's master control panel MASTER BATTERY switch set to OFF
Loader's hatch open
GENERAL INSTRUCTIONS:
NOTE
This procedure can also be done with loader's escape hatch
removed from tank.
Procedure
Step
NOTE
Shims are between plate and mount. Count shims taken
out at each of three mounting holes. Same number of
shims should be put back during installation.
1.
Using screwdriver, remove three screws (1) and three lockwashers (2). Remove plate (3)
from mount (4). Remove shims (5).
2.
Remove mount (4) from hatch (6).
3.
Remove bearing (7).
Remove seal (8).
4.
END OF TASK
Para 30-12
30-28