TM 9-2360-222-20-2-3-2
30-13.
MOUNT, SEAL, AND BEARING INSTALLATION PROCEDURE
Cross-tip screwdriver (Phillips)
TOOLS:
Adhesive (Item 3, App. A)
SUPPLIES:
Sealing compound (Item 18.1 App. A)
PERSONNEL One
JPG for procedure to use adhesives
REFERENCES:
LO 9-2350-222-12 for procedure to lubricate mount
GENERAL INSTRUCTIONS:
NOTE
This procedure can also be done with loader's escape
hatch removed from tank.
FRAME
1
PROCEDURE
TEP
Using adhesive, put on seal (1) (JPG).
1.
Put on bearing (2).
2.
Line up spring-loaded pin (3) with groove in hatch (4).
3.
4.
Put sealing compound on threads of screws (7).
Put mount (5) in hatch (4).
5.
NOTE
Make sure the same number of shims are put back as were
taken out during removal.
Using screwdriver, attach plate (6) to mount (5) with three screws (7), three lockwashers (8), and shims
6.
(9).
Make sure mount (5) turns easily. If not, do steps 1 thru 5 again.
7.
Lubricate assembly (LO).
8.
END OF TASK
Para 30-13
30-30 Change 1