TM 9-2350-222-20-2-3-2
165-MM AMMUNITION RETAINING CLAMPS REMOVAL PROCEDURE
28-6.
TOOLS: 7/16" socket (1/2" drive)
1/2" drive ratchet
7/16" combination wrench
PERSONNEL: One
EQUIPMENT LOCATION INFORMATION:
CALLOUT
FOLDOUT
EQUIPMENT
11
Driver's Master Control Panel
15
165-MM Six Round Ammunition Rack
18
165-MM Three Round Ammunition Rack
EQUIPMENT CONDITION: Driver's master control panel MASTER BATTERY switch set to OFF
Ammunition removed from ammunition retaining clamps (TM- 10)
This procedure can be done with ammunition rack installed
or removed from vehicle.
PRELIMINARY PROCEDURES:
If rack is installed, remove six round or three round ammunition
rack as applicable (para 28-2) or (para 28-4)
GENERAL INSTRUCTIONS:
T h i s procedure is typical for removing ammunition
retaining cIamps for three or six round ammunition racks.
Para 28-6
28-12
