TM 9-2350-22-20-1-5
SMOKE GENERATOR TEE-TO-TURBOSUPERCHARGER TUBE ASSEMBLY REPLACEMENT
(Sheet 4 of 5)
If adapter was removed from turbosupercharger
1.
elbow, remove adapter (A) from replacement.
tube and, using 1/2 inch wrench, install
adapter (A) to turbosupercharger elbow.
2.
If adapter (A) was not removed from
turbocharger elbow, remove adapter (A)
from replacement tube and return adapter to
supply.
Position tube (B) to engine and loosely connect it to adapter (A).
3.
Loosely connect tubes (C) to tee (D).
4.
Position tee (D) so the open port points
Using 9/16 inch wrench to hold tee (D), use
5/8 inch wrench and tighten tube (C) nuts
onto tee (D).
Using 1/2 inch wrench to hold adapter in
turbosupercharger elbow, use 5/8 inch
wrench and tighten tube (B) nut onto adapter
(A).
Using 9/16 inch wrench to hold tee (D), use
3/4 inch wrench and install and tighten
Ml-degree elbow (F) to tee (D). Position elbow
open port to face engine.
9.
Using 3/4 inch wrench, connect and tighten
solenoid output fuel hose (G) to 90-degree
elbow (F).
Go on to Sheet 5
TA140895