TM 9-2350-222-20-1-5
SMOKE GENERATOR INTERMEDIATE FUEL HOSE REPLACEMENT (Sheet 5 of 5)
5.
Install three clamps F) onto intermediate fuel hose (G).
6.
Position intermediate fuel hose (G) along top right side of engine and connect to output port of
fuel shutoff valve (H) and elbow (B) in shroud.
7.
Using 7/8 inch wrench, tighten hose connections.
8.
Using socket, instaII and tighten three assembled washer screws (J) to secure clamps (F) to engine.
WARNING
Never activate smoke generator in a building or closed area or
with personnel rear.
9.
Start engine (TM 9-2350-222-10) and run until normal operating temperatures are attained. Run
engine at 1600 rpm and set SMOKE GENERATOR switch ON for 10 seconds. Have one person
look for white smoke emitting from exhaust, turn SMOKE GENERATOR switch OFF, shut down
engine. If white smoke was not seen, troubleshoot (page 4-963).
10.
Check smoke generator lines for leaks. Correct as necessary.
11.
Install engine shroud (page 9-3).
End of Task
TA140878
23-26