TM 9-2350-222-20-1-5
SMOKE GENERATOR FRONT ENGINE FUEL HOSE REPLACEMENT (Sheet 4 of 4)
Install tee (C) onto bulkhead elbow (D) as shown.
Connect fuel-water separator hose (E) onto tee (C).
Connect smoke generator fuel hose (A) onto tee (C).
Adjust positions of tee (C) and hoses (A) and (E) for no interference with other parts. Using
7.
wrench, tighten tee (C) to elbow (D) and hoses (A) and (E) to tee (C) connections.
Position clamps (F) along hose (A) and, using socket, secure each clamp with assembled washer
screws (G).
WARNING
Never activate smoke generator in a building or closed area or
with personnel near.
9.
Start engine TM 9-2350-222-10) and run until normal operating temperatures are. attained. Run
engine at 1600 rpm and set SMOKE GENERATOR switch ON for 10 seconds. Have one person
look for white smoke emitting from exhaust, turn SMOKE GENERATOR switch OFF, shut down
engine. If white smoke was not seen, troubleshoot (page 4-963).
Check smoke generator fuel lines for leaks. Correct as necessary.
10.
Install engine shroud (page 9-3).
TA140873
23-21