TM 9-2350-222-20-1-5
REAR DRAIN VALVE MOUNTING BRACKETS REPLACEMENT (Sheet 2 of 2)
3.
Using socket, remove four screws (D), four
lockwashers (E), and two washers (F)' attaching
large bracket (G) to small bracket (H) and small
bracket (H) to hull floor (J). Throw lockwashers
away.
4.
Slide large bracket (G) off rod (K).
1.
Using socket, install two screws (A), new lockwashers (B), and flat washers (C) through oval-shaped
holes in small bracket (D) into holes in large bracket (E).
Slide large bracket (E) on rod (F).
2.
Using socket, install two screws (G) and new
3.
lockwashers (H) attaching small bracket (D) to
hull floor (J).
4.
Using 9/16 inch wrench, if necessary, screw
jamnut (K) all the way on rod (F).
5.
Screw clevis (L) on rod (F) the recorded
number of turns (page 16-160, NOTE).
6.
Using 9/16 inch wrench, tighten jamnut (K)
against clevis (L) while holding clevis (L) with
pliers.
7.
Install actuating lever (page 16-158).
End of Task
TA140773
