TM 9-2350-222-20-1-5
REAR DRAIN VALVE LINKAGE ADJUSTMENT (Sheet 4 of 7)
If clean pin (B) was not installed in clevis (C) in step 12, use fingers and install clevis pin (B) in
holes in clevis (C) and hole in lever (E).
Usig pliers, install new cotter pin (A) in clevis pin (B).
Pull alinement pin (D) out of hole in lever (E) and hole in bracket (F).
16.
If cleivs jamnut (G) was not tightened against clevis (C) in step 10, use wrench and tighten jamnut
17.
(G) while holding clevis (C) with pliers.
Make sure drain valve (M) opens when control lever (N) is in open position (TM 9-2350-222-10).
18.
If valve (M) does not open, perform steps 19 thru 30.
Go on to sheet 5
TA140777
16-165