TM 9-2350-222-20-1-4
STEERING CONTROL LINK ASSEMBLY REPLACEMENT (Sheet 3 of 3)
INSTALLATION:
Position link (A) and two washers (B) in connecting link (C).
1.
NOTE
Use hammer if necessary to install
shaft (D).
Install shaft (D) through link (C), washers (B),
2.
and link (A), until shaft (D) is flush with link
(c).
3.
Using adjustable wrench, install setscrew (E) and locknut (F) into link (C). Using 7/16 inch
wrench to hold locknut (F), tighten setscrew (E) into groove of shaft (D). Tighten locknut (F)
against link (C).
4.
wrench, tighten bolts (G) to 15-20 lb-ft (20-27 N-m).
5.
Using 5/16 inch wrench, install grease fitting (J) into link (A).
Lubricate steering controls (LO 9-2350-222-12).
6.
Close number 5 top deck grille door (TM 9-2350-222-10).
7.
Install transmission shroud (page 9-23).
8.
TA253539
End of Task
15-40 Change 1
