TM 9-2350-222-20-1-4
PARKING BRAKE PAWL AND BELLCRANK ADJUSTMENT (Sheet 3 of 9)
At side housing assembly, hold control (G) at flats using open end of 9/ 16 inch wrench and loosen
4.
jamnut (H) with a 15/16 inch wrench. Continue holding control (G), finger tighten nut (J) until nut
bottoms on control (G). Tighten nut (H) with a 15/16 inch wrench.
CAUTION
Do not tighten nut (J) with wrench,
shaft (K) will bind on control (G).
Finger tighten nut (J) only.
Push and pull on clevis (F). Be sure shaft (K)
5.
does not bind. If free movement occurs, go to
next step. If binding occurs, back off sleeve nut
(J). Visibly inspect packing (L) for damage.
Refer to page 3-70 for removal. Do not replace
packing. When complete repeat step 5.
TA253418
Go on to Sheet 4
13-18 Change 1
