TM 9-2350-222-20-1-4
PARKING BRAKE PAWL AND BELLCRANK ADJUSTMENT (Sheet 1 of 9)
TOOLS:
15/16 in. combination box and open end wrench (2 required)
9/16 in. combination box and open end wrench (2 required)
1/2 in. combination box and open end wrench
7/16 in. socket with 1/2 in. drive
Pry bar
Slip joint pliers
Thickness gage
Gage block, 3/16 inch (Figure 5, Appendix F)
FABRICATED TOOLS:
Gage block, 15/16 inch (Figure 5, Appendix F)
Gage block, 1-1/8 inch (Figure 5, Appendix F)
Locating pin (1/8 in. drill or welding rod 4 in. long)
SUPPLIES:
Cotter pin (MS24665-283) (4 required)
Gasket (10910888) (2 required)
Lockkwasher (MS35338-44) (8 required)
PRELIMINARY PROCEDURE:
NOTE
If your vehicle is equipped with the two-piece control assem-
bly, it must be separated at the disconnect.
ADJUSTMENT:
Using socket, remove eight nuts (A) and lockwashers (Al) securing cover and gasket (B) to brake
1.
housing assembly (C), Remove cover and gasket. Throw gaskets and lockwashers away.
13-16 Change 1