TM 9-2350-222-20-1-4
INFRARED POWER SUPPLY AND SHOCK MOUNT ASSEMBLY REPLACEMENT
(Sheet 3 of 5)
8.
Remove power supply (B) from bracket (L).
9.
Using 1/4 inch wrench to hold nut (S), use
screwdriver to remove two screws (T),
washers (U), and mount (V) from each end of
both brackets (L).
INSPECTION:
Inspect all parts for defects. Replace any defective parts.
NOTE
Mounting hardware used to mount power supply to brackets
is same for both ends of each bracket, except for end of
bracket not shown on illustration. Mounting hardware for
hidden bracket is described in step 4 below.
Go on to Sheet 4
TA139759
10-204
