TM 9-2350-222-20-1-4
INSTRUMENT PANEL CLUSTER ASSEMBLY REPAIR (Sheet 18 of 22)
Instrument Panel Wiring Harness Replacement (Sheet 1 of 4)
PROCEDURE INDEX
PAGE
PROCEDURE
Removal
Installation
TOOLS: 3/8 in. combination box and open end wrench
Flat-tip screwdriver
SUPPLIES: Silicone compound (Item 32, Appendix D)
Lockwasher (MS35338-43)
Lockwasher (MS35336-42) (4 required)
Remove instrument panel from vehicle (page 10-123)
PRELIMINARY PROCEDURE:
REMOVAL:
1.
Using screwdriver, remove four screws and
lockwashers (A) securing receptacle connector
(B) to panel. Throw lockwashers away.
2.
Using wrench, remove nut and lockwasher (C)
securing harness junction (D) to panel. Throw
lockwasher away.
3.
Disconnect two leads (circuits 27 and 36) from
engine oil pressure gage (E) by pulling out.
Go on to Sheet 2
TA139701
10-145
