TM9-2350-222-20-1-3
ACCELERATOR TUBE ASSEMBLY REPLACEMENT (Sheet 2 of 4)
Using 1/2 inch wrench, loosen nut (D) from clevis (C).
3.
Using pencil, mark location of clamp (E) on tube (F).
4.
Using 7/16 inch wrench, remove screw (G) and lockwasher (H) from clamp (E). Throw lockwasher
away.
NOTE
Count and write down number of turns needed to unscrew
clevis (C).
6.
Unscrew clevis (C) and nut (D) from tube (F).
7.
Using pliers, remove cotter pin (J) from pin (K). Throw cotter pin away.
Remove pin (K) from clevis (L).
8.
9.
Pull tube (F) toward rear of vehicle and remove tube (F).
Remove clamp (E), spring (M), and flat washer (N) from tube (F).
10.
11.
Using 1/2 inch wrench, loosen jamnut (P) while holding clevis (L) with pliers.
NOTE
Count and write down number of turns needed to unscrew
clevis (L).
Unscrew clevis (L) and jamnut (P) from tube (F).
12.
Go on to Sheet 3
TA149119
7-443