TM
9-2350-222-20-1-3
RIMER PUMP TO BULKHEAD UNION FUEL LINES REPLACEMENT (EARLY MODEL) (Sheet 3 of 5)
11. Using 11/16 inch wrench to hold union (w)
use 5/8 inch wrench and remove tube nut
(X) from union.
12. Remove tube assembly (Y) or (z).
CLEANING AND INSPECTION:
1.
Clean tube assemblies and nuts with rags. (Items 65, Appendix D).
2.
Inspect all parts for damage or wear. Replace any damaged or worn part.
INSTALLATION:
NOTE
To install primer pump fuel inlet lines do steps 1 through 10 and
14 through 16.
To install pump fuel outlet do steps 1 through 7 and 11 through
16.
Place tube assembly (A) or (B) in position.
1.
Using 5/8 inch wrench, connect tube nut (C)
2.
to union (D).
Go on to Sheet 2
TA253306
Change 1 7-225