TM9-2350-222-20-1-3
TUBE ASSEMBLY (FUEL INJECTION PUMP INLET TO BULKHEAD ELBOW) REPLACEMENT
(Sheet 5 of 5)
7.
Using fingers, install three tube clamps (H) on
tube assembly (A).
8.
Using 3/8 inch wrench and screwdriver, install
three screws and new self-locking nuts (J)
through tube clamps (H).
9.
Install cooling fans (page 9-49).
10.
Install ground hop kit (page 5-49).
11.
Perform powerplant test run (page 5-52).
12.
Install 2A powerplant (page 5-14) or 2D
powerplant (page 5-37).
End of Task
TA141507
7-36
