TM9-2360-222-20-1-3
TUBE ASSEMBLY (FUEL INJECTION PUMP INLET TO BULKHEAD ELBOW] REPLACEMENT
(Sheet 2 of 5)
NOTE
Use drain pan and rags (Item 65,
Appendix D) to catch fuel in hose
and tube assemblies.
REMOVAL:
1.
Using 7/8 inch wrench, remove hose assembly
(A) from bulkhead elbow (B).
2.
Using 1 inch wrench to hold nut of bulkhead
elbow (B) and 7/8 inch wrench, remove tube
assembly (C) from bulkhead elbow (B).
3.
Using 3/4 inch wrench to hold bulkhead elbow
(B) and 1 inch open end wrench, remove nut,
lockwasher, and flat washer (D) from bulkhead
elbow (B). Throw lockwasher away.
4.
Remove bulkhead elbow (B) from engine
bulkhead.
5.
Using 3/8 inch wrench and screwdriver,
remove three screws and self-locking nuts (E)
from tube clamps (F). Throw nuts away.
6.
Using fingers, remove three tube clamps (F)
from tube assembly (C).
Go on to Sheet 3
TA141504
7-33
