TM9-2350-222-20-1-3
FUEL RETURN LINES REPLACEMENT (2D ENGINE) (Sheet 6 of 10)
INSTALLATION:
1.
Using 15/16 inch wrench on elbow (A) and 3/4 inch wrench on vent valve (B), install vent valve
(B) in elbow (A).
2.
Using 3/4 inch wrench on vent valve (B) and 7/8 inch wrench on fuel return line (C), install fuel
return line (C) on vent valve (B).
Install clamp (D) on fuel return line (C).
3.
4.
Using screwdriver and 7/16 inch wrench, install screw (E) and nut (F) securing clamp (D).
Place cross tube (G) in vise and, using 7/16 inch wrench, install elbow (H) in cross tube (G).
5.
Remove from vise.
6.
Place cross tube (G) in position and, using hands, install flat washer (J), nut (K), and fuel return
line (L) on cross tube (G).
7.
Using 1-1/8 inch wrench, tighten nut (K) and fuel return line (L) on cross tube (G).
Go on to Sheet 7
TA141551
7-27
