TM 9-2360-222-20-1-3
MULTIPLE FLUID PRESSURE LINE CONNECTOR REPLACEMENT (Sheet 1 of 6)
PROCEDURE INDEX
PAGE
PROCEDURE
Removal
Inspection
Installation
TOOLS:
1/2 in. combination box and open end wrench
1-1/8 in. deep well socket with 1/2 in. drive
1/2 in, socket with 1/2 in. drive
Ratchet with 1/2 in. drive
11/16 in. combination box and open end wrench
1 in. combination box and open end wrench
1-1/8 in. open end wrench
Flat-tip screwdriver
SPECIAL TOOLS: Ground hop kit (Item 30, Chapter 3, Section I)
PRELIMINARY PROCEDURES: Remove powerplant (page 5-1)
Remove rear engine cooling fan (page 9-48)
REMOVAL:
1.
Using 11/16 inch wrench, disconnect hoses (A)
and (B) from connector (C).
Go on to Sheet 2
TA139434
6-66
