TM 9-2360-222-20-1-3
ENGINE MOUNTS (LEFT AND RIGHT) REPLACEMENT (Sheet 3 of 3)
INSTALLATION:
Position bolt (A) through bracket (B) and install
1.
nut (C). Using 1-1 /16 inch wrench to hold nut
(C) and 1-1/8 inch socket, tighten bolt (A).
Position bolt (D) through new lockwasher (E),
2.
bracket (B), mount (F), mounting (G), mount
(H), and bushing (J). Use 1-1/8 inch socket
tighten bolt (D) while holding bushing (J) with
3/4 inch drive T-slide and 36 inch bar
extension.
Using 1/2 inch socket, install two screws (K)
3.
through new lockwashers (L) and bracket (M)
into mounting (G).
Install 2A powerplant (page 5-14) or 2D
4.
powerplant (page 5-37).
TA139375
End of Task
6-8
