TM 9-2350-222-20-1-3
REAR POWERPLANT GUIDE (LEFT AND RIGHT) REPLACEMENT (Sheet 1of 2)
TOOLS: 9/16 in. socket with 1/2 in. drive
.
.
Hinged handle with 1/2in. drive (breaker bar)
Ball peen hammer
Long round nose pliers
Slip joint pliers
Chisel
Brass drift
SUPPLIES: Cotter pin (MS24665-136)
Connecting ring (8744683)
Sleeve bearing (5160090)
Wood block, 4 in, x 6 in. (approximately)
Lockwasher (MS35338-46)
Remove powerplant (page 5-1)
PRELIMINARY PROCEDURE:
REMOVAL:
Using socket, remove screw (A), lockwasher (B), and flat washer (C) securing rear powerplant guide
1.
(D) to support. Throw lockwasher away.
2.
Using hammer, tap guide (D) from mounting place. Remove guide from vehicle.
Using brass drift, drive bearing (E) from
3.
support. Throw bearing away.
Using long round nose pliers, remove
4.
cotter pin (F) and latch (G). ThrOW cotter
pin away.
Using chisel, cut ring (H).
5.
Using slip joint pliers, separate ring (H)
6.
and remove ring (H), spring (J), and pin
(K). Throw ring away.
TA2531S0
Go on to Sheet 2
6-4 Change 1
