TM 9-2350-222-20-1-3
TRANSMISSION MOUNTS (LEFT AND RIGHT) REPLACEMENT (Sheet 3 of 4)
NOTE
It may be necessary to turn universal joint to gain access to screws (L).
8.
Using 3/4 inch socket, remove three screws (L)
9.
Remove bracket (C) from transmission.
10. Using hammer, remove spacer (N) from bracket
(C).
CLEANING AND INSPECTION:
1.
Inspect bushing, mounts, and roller for
damages. If any parts are nicked, burred, or
out-of-round, replace damaged part.
INSTALLATION:
WARNING
Dry cleaning solvent P-D-680 is toxic
1.
Position bracket (A) in vise and, using
and flammable. To avoid injury wear
remover tool, install two mounts (B) into
protective goggles and gloves and use
bracket (A).
in a well-ventilated area. Avoid contact
with skin, eyes, and clothes, and do not
2.
Using 3-1/8 inch socket and T-slide handle,
breathe vapors. Do not use near open
install bushing (C) into bracket (A).
fire or excessive heat. The flash point
for Type I dry cleaning solvent is 100F
(38C), and for Type II is 140F (60C). If
you become dizzy while using dry
cleaning
solvent,
get
fresh
air
immediately and get medical aid. if
contact with eyes is made, wash your
eyes with water and get medical aid
immediately.
2.
Clean all parts with dry cleaning solvent
and wipe dry with rags.
Go to Sheet 4
6-11
Change 4