38
TM5-2430-200-10
Operation Section
Machine Features
Machine Features
Parking Brake
Do not apply the parking brake while the machine is
moving, unless an emergency exists.
With the engine running, this machine will spot turn
when the steering wheel is turned, even if the
transmission is in NEUTRAL.
To
avoid
personal
injury
due
to
unexpected
movement, engage the parking brake and make sure
the area is free of personnel before starting the
engine.
Parking brake switch (1) is located on the
Control console, to the right of the operator’s
seat.
Pull up on the switch to apply the parking brake.
NOTE: A lamp inside parking brake switch (1) will
indicate that the brake is applied.
Push down on the switch to release the parking brake.
Service Brakes
Depressing pedal (1) applies equal braking torque to both
front idlers. Increasing pedal stroke increases brake
torque.
This machine is equipped with an accumulator in the
brake system. the accumulator stores energy to
apply the brakes if the engine stops running. The
brake accumulator stores enough energy to apply the
service brakes five times after the engine stops.
When the accumulator pressure is gone, the spring-
applied parking brake will engage, and the machine
will stop suddenly.
NOTICE
Use caution when towing loads at transport speeds (up
to 15 mph). Reduce speed if towed load is not equipped
with brakes. Avoid hard braking applications.
NOTE: Never rest a foot on the pedal. Resting a foot
on the brake pedal causes unnecessary wear of the
brake disks.
