Undercarriage
Lubricate
Lubricate four undercarriage fittings on each side of
the machine. The four fittings are: (1) tension cylinder
pin, (2) front minor bogie pin, (3) major bogie pin, (4)
rear minor bogie pin.
NOTE: There are eight undercarriage fittings to be
lubricated at this service interval.
Check Balance
1. Start the engine. Refer to “Operation Section,
Before Starting Engine” and “Operation Section,
Engine Starting” in this manual.
2. Ensure that the suspension manual lockout valves
are open. Refer to “Operation Section, Machine
Features, Suspension Manual Lockout Valves” in
this manual.
3. Put the machine into SELF-DEPLOY mode. Refer to
“Operation Section, Machine Operation, Self-deploy
Mode” in this manual.
4. Move the machine to a flat surface, and engage the
parking brake. Refer to “Operation Section,
Machine Operation, Moving the Machine” and
“Operation Section, Machine Parking” in this
manual.
5. Check that the left and right side of the machine are
approximately the same distance off the ground.
Inform Unit Maintenance that the suspension must
be recharged if the machine is visibly tilted to the
left or right.
NOTE: If the fenders are bent, another point of
reference should be used.
NOTE: If necessary, an emergency suspension
charging can be performed in the field. For the
emergency charging procedure, refer to “Operation
Section, Machine Operation, Emergency Suspension
Charging” in this manual.
2
1
4
3
124
Maintenance Section
Every 10 Service Hours or Daily
TM5-2430-200-10
