TM 9-2350-222-20-1-4
PARKING BRAKE CONTROL ASSEMBLY REPLACEMENT (ENTINE MOUNTED)
INSTALLATION:
CAUTION
Make sure the metal casing of control assembly (A) is free to
rotate at both ends so as not to cause binding of the inner
purshrod.
Connect the inner pushrods (B) of control assemblies (A) and (C) and slide nut (D) over connection,
1.
Manually tighten disconnect nut (D) on control assembly (C) finger tight.
Using a 15/16 inch wrench, install nut (E),
2.
Install new lockwasher (F), bracket (G),
3.
and new lockwasher (H) on control assembly (A).
Using 15/ 16 inch wrench, install nut (J).
4.
Install new packing (K) in nut (L).
5.
6.
Using a 15/16 inch wrench, install new
nut (L).
Using an adjustable wrench, install con-
7.
nector (M) on end of control assembly (A).
TA253453
Go on to Sheet 5
13-98.4 Change 1