TM 9-2350-222-20-1-4
PARKING BRAKE CONTROL ASSEMBLY REPLACEMENT (ENGINE MOUNTED)
(Sheet 1 of 7)
TOOLS:
7/8 in. combination box and open end wrench
9/16 in. socket with 3/8 in. drive
Ratchet with 3/8 in. drive
7/16 in. combination box and open end wrench
9/16 in. combination box and open end wrench
15/1 6 in. combination box and open end wrench
Adjustable wrench
Long round nose pliers
Slip joint pliers
5 in. extension with 3/8 in. drive
6 in. rule
7/8 in crowfoot wrench with 3/8 in. drive
SUPPLIES:
Lockwasher (2 required)
Lock washer
Preformed packing
PRELIMINARY
PROCEDURES:
Remove transmission shroud (page 9-20)
Block tracks (TM 9-2350 -222-1 O)
REMOVAL:
1.
At flats, use an adjustable wrench to hold control assembly (A), use 7/8 inch wrench to loosen
disconnect nut (B) on control assembly (C). separate control assemblies (A and C).
Go on to Sheet 2
Change 5
13-98.1
