TM 9-2350-222-20-1-4
PARKING BRAKE CONTROL ASSEMBLY REPLACEMENT (ENGINE COMPARTMENT)
(Sheet 6 of 15)
24
Using two 9/16 inch wrenches, remove two
nuts (AH) by removing lower nut first while
holding upper nut. (Note - your system may
only have one nut).
25.
Pull control assembly (AJ) out of housing
(AK). When control assembly is pulled
out, washers (AL), spring (AM), packing
with retainer (AF), and nut (AE) will fall
free.
26.
Throw packing with retainer (AF) away.
27.
Remove and throw away preformed pack-
ing from inside of nut (AE).
28.
On early model only, using adjustable
wrench on flats of inner rod (AN) and 9/16
inch wrench, back off nut (AP) on left or
right side.
GO on to Sheet 7
TA253441
Change 1 13-89