PARKING BRAKE CONTROL ASSEMBLY REPLACEMENT (ENGINE COMPARTMENT)
(Sheet 8 of 15)
36. Remove control assembly (AY).
37. Using 9/16 inch wrench on flats of control
assembly (AY), use 15/16 inch wrench and
remove nut (AZ).
1. Inspect all items removed for damage or wear.
2. Replace parts as necessary.
Check control assembly moveable section for
end containing cotter pin hole through
threaded end section.
Using 9/16 inch wrench on flats of control
assembly and, using 15/16 inch wrench,
install nut (A) onto control assembly (B).
Go on to Sheet 9