TM 9-2350-222-20-1-4
PARKING BRAKE CABLE ADJUSTMENT (Sheet 2 of 4)
3.
Using pliers, remove cotter pin washer and pin (D) holding brake cable (E) to bellcrank (F) at
transmission (G). Throw cotter pins away.
4.
Rotate bellcrank (F) to aline holes in
bellcrank (F) with hole in bracket (H).
Insert 1/8 inch locating pin through bell-
crank (F) and bracket (H).
NOTE
L o c a t i n g pin must slide up and
down freely while performing
remaining adjustments.
5.
Push parking brake cable (E) inward until
it stops.
6.
Check forward end of cable at driver's station for free movement.
TA253426
Go on to Sheet 3
Change 1 13-21