TM 9-2350-222-20-1-4
FINAL DRIVE STUD REPLACEMENT (Sheet 2 of 2)
INSTALLATION:
1.
Using clean brush (Item 10, Appendix D),
lightly coat tapped stud holes (A) with primer
(Item 48, Appendix D).
2.
Using clean brush, lightly coat threads of studs
(B) with sealing compound (Item 26, Appendix
D).
NOTE
Any stud installed in area (C)
must protrude 2-1 5/1 6 inches
out of tapped stud hole. Any
stud installed in area (D) must
protrude 2-1/4 inches out of
tapped stud hole.
3.
Thread two hex nuts on new stud and jam the
nuts. Using 1-1 /2 inch wrench on top nut,
install new stud.
4.
End of Task
TA140300
12-7