TM
9-2360-222-20-1-4
FINAL DRIVE (LEFT AND RIGHT) REPLACEMENT (Sheet 3 of 6)
Check if lifting eye (A) is installed in final
1.5
drive (B).
If lifting eye (A) is installed in final drive
2.
(B), check it for distortion or cracks.
If lifting eye (A) is distorted or cracked, usingpinch bar through eyehole (C), turn and remove lifting
3.
eye (A) from final drive (B).
Start threads of new lifting eye (A) into final drive (B).
4.
Using pinch bar, turn and tighten lifting
5.
eye (A).
If lifting eye (A) is not installed in final drive
6.
(B), using socket wrench handle, remove plug
from lifting eyehole in final drive (B).
Install new liftig eye (A) as in steps 4 and 5
7.
above.
CAUTION
Use hoist with 1100 pounds
minimum capacity.
Connect hoist to lifting eye (A) on final
8.
drive (B).
TA253395
Go on to Sheet 4
12-4 Change 1
