ENGINE COMPARTMENT DISCHARGE MANIFOLD REPLACEMENT (FIXED FIRE
EXTINGUISHER) (Sheet 2 of 4)
Using 1/2 inch wrench, remove screw (H) and
lockwasher (J) from manifold (G). Throw
Go to inside of turret for the following steps.
Locate manifold (G) and tube (K) through
center sub-floor access plate.
Using 1-1/16 inch wrench to hold adapter (L),
use 1-1/4 inch wrench and loosen connector (K)
from adapter (L).
Using 1/2 inch wrench, remove screw (M) and
lockwasher (N) from manifold (G). Throw
Remove manifold (G) from vehicle.
Secure manifold (G), in vise.
Using 7/8 inch wrench, remove elbow (F) from
Using 3/4 inch wrench, remove adapters (A)
and (C) from manifold (G).
Using 1-1/16 inch wrench, remove adapter (L)
from manifold (G).
Make sure that all connections and seating surfaces are free of nicks, burrs, or other defects that
could cause leakage. Replace any damaged parts.
Go on to Sheet 3