PERSONNEL HEATER REPAIR (Sheet 7 of 8)
Ignition Control Replacement (Sheet 1 of 2)
TOOLS: Flat-tip screwdriver
REFERENCE: TM 9-2350-222-10
PRELIMINARY PROCEDURES: Set HEATER MASTER switch to OFF (TM 9-2350-222-10)
Disconnect electrical connector (page 19-24)
Remove heater cover (page 19-24)
Disconnect two leads (A) and (B).
Using screwdriver, remove screw and
lockwasher (C) securing third lead (D)
(N.O.) to flame detector switch (E).
Disconnect lead (D) from switch (E).
Using screwdriver, loosen (do not remove)
two screws (F) at slotted mounting holes.
Remove plastic band (G) by pulling apart.
Using screwdriver, remove two screws (H).
Remove ignition control (J) from personnel