TM 9-2350-222-20-1-5
PERSONNEL HEATER REPAIR (Sheet 3 of 8)
Heater Igniter Replacement (Sheet 3 of 4)
INSTALLATION:
1.
Install ignitor (A) into tube.
2.
Using hand, press down on igniter (A) and,
using screwdriver on pin (B), turn ignitor (A)
clockwise to secure in tube.
BOTH WHITE LEADS
Feed shorter lead (C) thru cutaway portion of
inlet (D) and secure to ground terminal (E).
Feed white lead (F) (longer lead) thru
cutaway portion of inlet (D) and secure to
ignition control (G).
5.
Place electrical inlet connection (D) in position
on personnel heater.
6.
Using screwdriver, turn two captive screws (H)
one quarter turn clockwise to secure inlet (D) to
personnel heater.
Mount cover (J) on heater.
Using screwdriver, turn two screws (K) to
secure cover (J).
9.
Connect electrical connector (L) to heater
electrical inlet (D).
10.
Screw coupling (M) over connection.
11.
Install slave receptacle (page 10-154).
12.
Connect battery ground straps (page 10-283).
Go on to Sheet 4
TA141251