PERSONNEL HEATER REPAIR (Sheet 8 of 8)
Ignition Control Replacement (Sheet 2 of 2)
Mount igniter control assembly (A) to heater.
Using screwdriver to four screws (B), secure
ignitor control (A) to heater.
terminal (D) (N.O.) on flame detector switch
Install screw and lockwasher (F) securing
lead (C) to flame detector switch (E).
Using screwdriver, tighten screw (F).
Connect two leads (G) and (H) to ignition
Install plastic band (J).
Perform operational check (TM 9-2350-222-10).
Install right driver's periscope (TM 9-2350-222-10).
End of Task