TM 9-2350-222-20-1-5
LINEAR ACTUATING (RAM) CYLINDER AND GUARDS REPLACEMENT (Sheet 7 of 8)
Remove plastic plug and cap from ends of hose
15.
assembly (N).
Using 1-3/8 inch wrench on nut of hose
16.
assembly (N) and 1-1/16 inch wrench on nut of
elbow (F), install hose assembly.
17.
Using 1-1/2 inch wrench, install bushing (P).
Using 1-1/16 inch wrench, install adapter (Q)
18.
with swivel nut facing down.
19.
Using 1-3/8 inch wrench on nut of hose
assembly (R) and 1-1 /16 inch wrench on nut of
adapter (Q), install hose assembly.
20.
Place nut (S) and packing (T) on elbow (U).
21.
Using adjustable wrench on elbow and 1-3/8
inch wrench on nut (S), install elbow.
Using 1-1/4 inch wrench on end nuts of hose
22.
assemblies (R) and (N), install hose assemblies.
23.
Raise and lower moldboard several times (TM
9-2350-222-10) and check for leaks. Tighten
fittings and replace or repair fittings, hoses, or
cylinders as required.
Position cover (V) over hose assemblies (R) and
24.
(N) and aline holes.
25.
26.
Using 15/16 inch socket, install two screws (W).
Go on to Sheet 8
18-32