LINEAR ACTUATING (RAM) CYLINDER AND GUARDS REPLACEMENT (Sheet 6 of 8)
Attach sling and, using lifting device,
position cylinder (B) with trunnions over
Aline two caps (G) over cylinder trunnion.
Using 1-1/2 inch socket, install four screws
Pull or push ram arm up or down and
aline with pushbeam, then insert pin (J)
(with locking groove facing forward).
11. Place new lockwasher (K) on screw (L).
12. Position lock (M) on pushbeam and pin (J).
Using 15/16 inch socket, install screw (L).
13. Remove plastic plug from lower fluid port
14. Remove sling and lifting device.