BRAKE CONTROL PEDAL AND BRACKET REPAIR AND REPLACEMENT
(Sheet 5 of 5)
Position control pedal (P) on levers (C) and
Insert two pins (Q).
Using pliers, install two lockpins (R) through
holes in pins (Q).
Place new lockwasher (S) on each of two screws
Position bracket (E) over locating pin of mount
and aline mounting holes.
Holding bracket (E) slightly raised, tighten rear
screw (J) finger tight.
Insert two screws (T) in front mounting holes
and tighten finger tight.
16. Using 9/16 inch wrench, tighten screw (J) and
two screws (T).
End of Task