FINAL DRIVE VENTING SYSTEM REPLACEMENT (Sheet 10 of 10)
If new tubing is being replaced, obtain from supply two tube
nuts (MS51823) and two sleeves (MS51825) and install onto
new tubing (T).
20. Using fingers, connect tubing (T) to elbow (S) and tee (R).
21. Using torque wrench and 9/16 inch crowfoot, tighten tubing (T) nuts to elbow (S) and tee (R)
75-85 lb-in (8.4-9.5 N.m).
Install four clamps (U) onto tubing (T).
23. Using 7/1i6 inch wrench, install and tighten screws (V) and new lockwashers (W) securing clamps (U)
End of Task
5 12-29/ (12-30 blank)