TM 9-2350-222-20-1-4
BRAKES ADJUSTMENT (Sheet 4 of 8)
CAUTION
Make sure brakes are fully released before making brake
adjustment. Failure to fully release brakes can cause internal
damage to cross-drive transmission.
6.
Using 7/16 inch wrench, turn brake
adjusting worm (F) about 25 turns toward
rear of vehicle.
7.
Using 7/16 inch wrench, attempt to line up
index line (B) marked R with index mark (C)
by turning brake adjustment worm toward
front of vehicle.
8.
If index line (B) marked R and index mark (C)
are lined up, using 7/16 inch wrench, hold
brake adjusting worm (F). Using 15/16 inch
wrench, tighten locknut (E).
NOTE
If index line (B) marked R, and index mark (C) are not lined up,
notify supervisor that brakes require higher level maintenance.
GO on to Sheet 5
TA140315
13-5