FINAL DRIVE VENTING SYSTEM REPLACEMENT (Sheet 7 of 10)
6. Using fingers, connect tube assembly (C) to tee (F).
7 . Install clamp (G) onto tube assembly (H) and position tube assembly (H) onto hull.
8 . Using fingers, connect tube assembly (H) to tee (F).
Using adjustable wrench to hold tee (F), and using torque wrench with 11/16 inch crowfoot tighten as-
semblies (C and H) 75-85 lb-in (8.4-9.5 N m).
10. Using 7/16 inch wrench, install and tighten screw (J), and new lockwasher (K) securing clamp (G) to
Go on to Sheet 8
12-26 Change 1