TM 9-2350-222-20-1-4
CAPACITOR AND HOUSING ASSEMBLY REPLACEMENT, RIGHT FUEL TANK
(Sheet 6 of 9)
INSTALLATION:
1.
Position new gasket (A),
cover (B), and new gasket
(C) onto cable and adapter (D).
Aline screw holes.
2.
Using flat-tip screwdriver,
install four screws (E) and
new Iockwashers (F) securing
cover and gaskets to adapter (D).
3.
Position new gasket (G) between cover (B) and
fuel tank (H).
4.
Position cable that is attached to rear of cover
(B) through gasket and lay in fuel tank.
5.
Using 1/2 inch socket, install eight screws
(J) and washers (K) securing cover (B) to
fuel tank (H).
6.
Using torque wrench, tighten screws (J) to
5-10 lb-ft (6-13 N.m).
7.
Using flat-tip screwdriver, secure electrical lead
(L) of housing and capacitor (M) to adapter (D)
with screw (N) and new lockwasher (P).
Position capacitor and housing (M) onto
8.
cover (B). Using flat-tip screwdriver,
and flat washers (R) securing capacitor
and housing (M) to cover (B).
9.
Using slip joint pliers, install lockwire (S) onto
screws (Q).
Go on to Sheet 7
Change 1 10-407