MASTER CONTROL PANEL REPAIR (Sheet 34 of 65)
Circuit Breaker Replacement (Sheet 5 of 7)
REMOVAL OF GAGE CIRCUIT BREAKER:
Using screwdriver on screw (A) and wrench on nut (B), remove four screws (A), lockwashers (C),
and nuts (B) securing connector (D) to panel. Throw lockwashers away.
Remove connector (D) from panel and
Using fingers, remove two electrical connectors
from rear of circuit breaker (E) by pulling out.
Using screwdriver, remove two screws (F) and
lockwashers (G) securing circuit breaker to
panel. Throw lockwashers away.
Remove gage circuit breaker (E).
Go on to Sheet 6