MASTER CONTROL PANEL REPAIR (Sheet 29 of 65)
Bilge Pump Switch and Indicator Light Replacement (Sheet 4 of 4)
Apply silicone compound (Item 32, Appendix D) to two male electrical connectors.
Using fingers, connect two electrical connectors to rear of switch (H) by pushing in
Before installing switch (H), make sure switch (H) is in OFF
position. If OFF position is not marked on switch (H), use
multimeter to make sure switch (H) is in OFF position.
10. Place switch (H) in position on panel.
11. Using screwdriver, install two screws (J) and new lockwashers (K) securing switch (H) to panel.
End of Task