AIR CLEANER INTAKE ELBOW REPLACEMENT (Sheet 3 of 3)
Position new gasket (A) onto studs of air cleaner.
Install elbow (B) onto studs of air cleaner.
Install 10 new self-locking nuts (C) onto studs to secure elbow (B) to air cleaner.
Using socket or 9/16 inch wrench, tighten 10 self-locking nuts (C).
Install hose (D) onto elbow (B).
Slide clamp (E) up over hose (D) and onto elbow (B).
Using 3/8 inch wrench, tighten clamp nut (F) to secure clamp (E).
If your vehicle is not equipped with final drive vent line
(H), skip steps 8 and 9 and go on to step 10.
Using 5/8 inch wrench, install adapter (G) in elbow (B).
Using 11/16 inch wrench, install and tighten vent line (H) on adapter (G).
Using 5/8 inch wrench, install plug (J) in hole in left intake elbow (B).
Close top deck grille doors (page 16-24, steps 8 and 9).
End of Task