TM 9-2350-222-20-1-3
POWERPLANT REPLACEMENT (2D ENGINE) (Sheet 18 of 23)
32.
Remove protective coverings from
hydraulic brake line openings.
NOTE
If your vehicle is equipped with the
hydraulic brake quick-disconnect,
proceed to step 33.1.
33.
Using 9/16 inch wrench, install brake
line (V).
WARNING
Dry cleaning solvent P-D-680 is toxic
and flammable. To avoid injury wear
protective goggles and gloves and use
in a well-ventilated area. Avoid contact
with skin, eyes, and clothes, and do not
breathe vapors. Do not use near open
fire or excessive heat. The flash point
for Type I dry cleaning solvent is 100F
(38C), and for Type II is 140F (60C). If
you become dizzy while using dry
cleaning
solvent,
get
fresh
air
immediately and get medical aid. If
contact with eyes is made, wash your
eyes with water and get medical aid
immediately.
33.1.
Using dry cleaning solvent, clean both
halves of quick-disconnect coupling (V.1).
Check spring action of movable collar (V.2) on
33.2.
female half of quick-disconnect coupling.
If action is not smooth, pour dry cleaning
solvent between collar (V.2) and inner element
and work collar (V.2) back and forth until free of
dirt and grime and action is smooth.
Using dry rags, dry both halves of quick-
33.3.
disconnect coupling.
Connect female half of quick-disconnect
33.4.
coupling to male half by twisting clockwise
until collar (V.2) snaps over locking nut (V.3). Be sure
collar (V.2) is securely locked down over locking nut (V.3).
Go on to Sheet 18.1
Change 4
5-42