POWERPLANT REPLACEMENT (2D ENGINE) (Sheet 19 of 23)
Alining steering rod linkage flats, install
Using 7/16 inch wrench, tighten capscrew
Remove protective coverings from air cleaner
outlet elbow (Y) and turbosupercharger elbow
Manually install two air cleaner outlet hoses
(Z) on each side of powerplant.
Using socket, tighten adjusting nut (AA)
o n clamp (AA.1) to eliminate clearance
between hasp and "T" bolt. Turn nut one
a d d i t i o n a l turn.
Using socket and torque wrench, tighten
nut of clamp (AA.2) to 25 to 35 lb. in. (3
to 4 Nm).
Go on to Sheet 19.1