TM
9-2350-222-20-1-4
GREASE ACTUATED TRACK ADJUSTING LINK REPLACEMENT (Sheet 1 of 7)
PROCEDURE INDEX
PAGE
PROCEDURE
Removal
Installation
Slip joint pliers
TOOLS: 15/16 in. socket with 1/2 in. drive
3/8 in. combination box and open
15/16 in. socket with 3/4 in. drive
end wrench
1-1/8 in. socket with 1/2 in. drive
3/4 in. combination box and open
end wrench
5 in. extension with 1/2 in. drive
Torque wrench with 3/4 in. drive
5 in. extension with 3/4 in. drive
(0-600 ft-lb) (0-813 N.m)
12 in. adjustable wrench
Lifting device (2,000 lbs. capacity)
Slide hammer puller (Item 12, Chapter 3, Sect
SPECIAL TOOLS:
Remover and replacer tool (Item 18, Chapter 3, Section I)
Sling assembly (Item 23, Chapter 3, Section 1)
SUPPLIES:
Grease (Item 36, Appendix D)
Lockwasher (MS35338-67)
Pin, cotter (MS24665-497)
REFERENCE: TM 9-2350-222-10
PERSONNEL:
Two
Release track tension (TM 9-2350-222-10)
PRELIMINARY
PROCEDURES:
Disconnect track between compensating idler wheel
and number 1 roadwheel (TM 9-2350-222-10)
Remove front fender (page 16-65)
Go on to Sheet 2
TA249133
14-62.2
Change 3