MECHANICAL TRACK ADJUSTING LINK REPAIR (Sheet 3 of 3)
Using hammer and center punch, stake bearing
(B) into link (A) in three places (both sides).
Install bolt (C) and new lockwasher (D) at other
end of link.
Using 9/16 inch wrench, tighten bolt (C) in
Using 7/16 inch wrench, tighten new grease
fitting (E) into position in link (A).
For easy access with grease gun, fitting (E) should be pointing
outward when link (A) is installed to tank.
Using grease gun, squirt grease (Item 36, Appendix D) through fitting (E) to make sure it is not
End of Task