TM 9-2350-222-20-1-4
MECHANICAL TRACK ADJUSTING LINK REPAIR (Sheet 2 of 3)
Using hammer and chisel, cut stakes at three
3.
places (both sides) that hold bearing (E) in eye
end of link (B).
Position remover-replacer tool (Item 14, Chapter
4.
3, Section I) to bearing in link (B). Using 3/4
inch sliding tee, press bearing out of link eye.
Inspect parts (A) through (E). Replace them as
5.
necessary.
ASSEMBLY:
Position link (A) so eye end is facing upward.
1.
NOTE
Make sure bearing is every
mounted in link eye.
Using remover-replacer tool (Item 14, Chapter
2.
3, Section I), carefully press bearing (B) into eye
of link (A).
TA249131
Go on to Sheet 3
Change 3
14-62